Chapter CIII: Section 16: Couplings for Shafting

(_See also p. 42._)

=1994. Coupling to allow two shaft ends to run a little out of line;= the centre piece has a cross feather at each end at right angles to each other, which engage with cross grooves in the shaft end pieces.

=1995. Split sleeve coupling= tightened on the shaft by two cone bushes and nuts.

=1996. Flange coupling,= with recessed grooves for the bolt heads and nuts.

=1997. Angle coupling= for shafts, instead of bevil gearing.

=1998. Angle coupling= for shafts at any angle (shown at angle of 90°) consisting of four crank pins sliding and revolving in holes bored in the shaft ends.